Chelsio Communications N210 Uživatelská příručka stáhnout pdf (Strana 5)

5 | P a g e

Confidential

Hardware Installation

1. Shutdown and power off your system.

2. Power off all remaining peripherals attached to your system.

3. Unpack the Chelsio Ethernet adapter and place it on an anti-static surface.

4. Remove the system case cover according to the system manufacturer‟s instructions.

5. Remove the PCI filler plate from the slot where you will install the 10Gb Ethernet

adapter.

For maximum performance, it is highly recommended to install the adapter into a PCI-X slot

running at 133Mhz or PCIE x8 slot.

6. Holding the Chelsio Ethernet adapter by the edges, align the edge connector with the PCI

connector on the motherboard. Apply even pressure on both edges until the card is firmly

seated. It may be necessary to remove the XFP/SFP (optics) modules prior to inserting the

adapter.

7. Secure the Chelsio Ethernet adapter with a screw, or other securing mechanism, as

described by the system manufacturer‟s instructions. Replace the case cover.

8. Connect a fiber cable, multi-mode for short range (SR) optics or single-mode for long

range (LR) optics, to the 10Gb Ethernet adapter or regular Ethernet cable for the 1Gb

Ethernet adapter.

1 2 3 4 5 6 7 8 9 10 ... 31 32

Žádné komentáře

Chelsio Communications N210 Uživatelská příručka Strana 5