Chelsio Communications Chelsio T4 Uživatelská příručka stáhnout pdf (Strana 153)

100

101

Chapter IX. FCoE Full Offload Initiator

ii. To check the list of targets discovered from a particular FCoE port, first find out the wwpn of

the initiator local port under sysfs. The hosts under fc_host depends on the number of ports

on the adapter used.

[root@host]# cat /sys/class/fc_host/hostX/port_name

iii. After finding the localport, go to the corresponding Remote port under sysfs # cat

/sys/class/fc_remote_ports/rport-X:B:R where X is the Host ID, B is the bus ID and R is

the remote port.

Alternatively the locaports can also be found using cxgbtool

[root@host]# cxgbtool stor –a <adapter no> --show-lnode

After finding out the wwpn of the local node, to verify the list of targets being discovered, use the

following command.

[root@host]# cxgbtool stor –a <adapter_no> --show-rnode --wwn=<wwpn of

lnode>

R can correspond to NameServer, Management Server and other initiator ports

logged in to the switch and targets.

Note

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 373 374

Komentáře k této Příručce

Žádné komentáře

Chelsio Communications Chelsio T4 Uživatelská příručka Strana 153

Komentáře k této Příručce