Chelsio Communications Chelsio T4 Uživatelská příručka stáhnout pdf (Strana 72)

100

101

Chapter IV. iWARP (RDMA)

vii. Run exportfs to make local directories available for Network File System (NFS) clients to

mount.

[root@host]# exportfs

Now the NFS-RDMA server is ready.

Client-side settings

Follow the steps mentioned below at the client side.

i. Load the iwarp modules and make sure peer2peer is set to 1. Make sure you are able to ping

and ssh to the server Chelsio interface through which directories will be exported.

ii. Load the xprtrdma module.

[root@host]# modprobe xprtrdma

iii. Run the showmount command to show all directories from server as:

[root@host]# showmount –e <server-chelsio-ip>

iv. Once the exported directories are listed, mount them as:

[root@host]# mount.rnfs <serverip>:<directory> <mountpoint-on-client> -i –o

rdma,port=2050

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 373 374

Komentáře k této Příručce

Žádné komentáře

Chelsio Communications Chelsio T4 Uživatelská příručka Strana 72

Komentáře k této Příručce